Model No.: LP16-400DFseries
Polymer PTC Re-settable Fuse Series
Product Dimensions For Radial-leaded Devices
|Part number ||Dimension|
Thermal Derating Chart-IH(A)
|Part number ||Hold current|
Electrical Characteristics at 25ºC
|Part number ||IH||IT||Vmax||Imax||Max. Time-to-trip||Pd typ||Rmin||R1max||Figures for|
IH=Hold current: maximum current at which the device will not trip at 25ºC still air.
IT=Trip current: minimum current at which the device will always trip at 25ºC still air.
Vmax=Maximum voltage device can withstand without damage at rated current.
Imax=Maximum fault current device can withstand without damage at rated voltage.
Ttrip=Maximum time to trip at assigned current.
Pdtyp=Typical power dissipation: typical amount of power dissipated by the device when in state air environment.
Rmin=Minimum device resistance at 25ºC prior to tripping.
R1max=Maximum device resistance measured after 1 hour post one-time trip.
Part Numbering System
Other necessary information
Test Procedures And Requirements
|Test||Test Conditions||Accept/Reject Criteria|
|Resistance||In still air @ 25ºC||Rmin≤R≤Rmax|
|Time to Trip||Specified current, Vmax, 25ºC||T≤maximum Time to Trip|
|Hold Current||30min, at IH||No trip|
|Trip Cycle Life||Vmax, Imax, 100cycles||No arcing or burning|
|Trip Endurance||Vmax, 24hours||No arcing or burning|
* Methods: IR, Vapor phase oven, hot air oven, wave solder, soldering temperature should not exceed GB-T2423 request.
* Devices can be cleaned using standard industry methods and solvents.
If reflow temperatures exceed the recommended profile, devices may not meet the performance requirements.
The maximum ambient temperature shall not exceed 40ºC. Storage temperatures higher than 40ºC could result in the deformation of packaging materials. The maximum relative humidity recommended for storage is 70%. High humidity with high temperature can accelerate the oxidation of the solder plating on the termination and reduce the solderability of the components. Sealed plastic bags with desiccant shall be used to reduce the oxidation of the termination and shall only be opened prior to use. The products shall not be stored in areas where harmful gases containing sulfur or chlorine are present.
PPTC devices are intended for protection against occasional over-current or over-temperature fault conditions, and should not be used when repeated fault conditions are anticipated. Operation beyond maximum ratings or improper use may result in device damage and possible electrical arcing and flame.
The specification is intended to present application, product and technical data to assist the user in selecting PPTC circuit production devices. However, users should independently evaluate and test the suitability of each product. Wayon makes no warranties as to the accuracy or completeness of the information and disclaims any liability resulting from its use. Wayon's only obligations are those in the Wayon Standard Terms and Conditions of Sale and in no case will Wayon be liable for any incidental, indirect, or consequential damages arising from the sale, resale, or misuse of its products. Wayon reserves the right to change or update, without notice, any information contained in this specification. Contact us if you need more details on PPTC Resettable Fuse. We are ready to answer your questions on packaging, logistics, certification or any other aspects about PPTC Resettable Fuse、PPTC Resettable Fuse. If these products fail to match your need, please contact us and we would like to provide relevant information.
Product Categories : PPTC Resettable Fuse