IEC Inlet Filters with Single Fuse

Features and Beneifits of IEC Inlet Filters with Single Fuse:

• Specially designed for standard IEC connector, fast and simple installation, highly cost effective.
• With oneφ5x20mm F type glass fuse.
• FT110I-A series are general purpose one-stage common mode filters.
• Excellent attenuation performance for interference from 150KHz to 30MHz.

Typical Applications of Electronic Line Filters:

• IT, telecommunication equipment
• Instruments and meters
• Household small tools
• Test and measurement equipment
• Electronic equipment requiring connection of standard plug

Technical Data of EMI RFI Line Filters:

1. Storage of IEC EMI Filters:

• The EMI filters mustn't be left out in the heat of the sun or exposed to the rain, it should be stored in warehouse with good ventilation, surrounding temperature between -30℃ and +65℃ , the highest relative air humidity lower than 90%, and no corrosive liquid or gas.

2. Installation of EMI RFI Line Filters:

• Electronic Line Filters should be installed at power input, and the line inside the chassis be as short as possible to reduce radiated interference.
• Both input and output lines of Inverter filters neither be intersected nor be tied up by string.
• Make sure the mounting flange fully grounded, and keep the ground cable as short as possible if filters are connected to other equipment.
• If the terminal is stud, please use two spanners to fasten the screw nut when connecting to avoid stud rotating and thus causing changes to the internal circuit and consequently leading to filters arcing, short circuit, broken down or the filtering effect worsened.
• First use spanner1 to fix the screw nut near the metal case, then use spanner2 to tighten the screw nut in front( shown as Figure1), otherwise the terminals may be damaged.
• Apply the same for the connection of other phases.

Requests for samples of any catalog item are available for engineering evaluation Free of Charge.

All EMI Filters are RoHS compliant and approvals held include CE, UL,cUL and TUV.

All quality control procedures are fully documented and available for review. FILTEMC is ISO 9001 compliant.

Contact us if you need more details on IEC EMI Filters. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Electronic Line Filters、EMI RFI Noise Filters. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : AC EMI Filter > IEC Filter